You are here

What is Power Line Communication? | サイプレス セミコンダクタ

What is Power Line Communication?

2018 年 2 月 25 日


Power Line Communication (PLC) is a communication technology that enables sending data over existing power cables. This means that, with just power cables running to an electronic device (for example) one can both power it up and at the same time control/retrieve data from it in a half-duplex manner.


PLC Market: 概要


For the purpose of understanding, PLC can be broadly viewed as:

  1. Narrowband PLC
  2. Broadband PLC

Narrowband PLC works at lower frequencies (3-500 kHz), lower data rates (up to 100s of kbps), and has longer range (up to several kilometers), which can be extended using repeaters. Broadband PLC works at higher frequencies (1.8-250 MHz), high data rates (up to 100s of Mbps) and is used in shorter-range applications.

Recently, narrowband Power Line Communication has been receiving widespread attention due to its applications in the Smart Grid. Another application that narrowband PLC has been used in is smart energy generation, particularly in micro-inverters for solar panels.

Broadband PLC, in contrast, has mainly found acceptance as a last-mile solution for Internet distribution and home networking. With its high data rates and no additional wiring, broadband PLC is seen as an exciting and effective technology for multimedia distribution within homes. This optimism in the market is reflected by the recent acquisitions of Intellon by Atheros, Coppergate by Sigma, DS2 by Marvell, and Gigle by Broadcom, all in the Home Area Networking (HAN) segment.

There is another way to classify Power Line Communication and that is:

  1. PLC over AC lines
  2. PLC over DC lines

While most companies are currently geared towards providing AC-PLC solutions, PLC in DC lines also has applications. Two such applications are PLC over the DC-bus in distributed energy generation, and PLC in transportation (electronic controls in airplanes, automobiles and trains). This use reduces wiring complexity, weight, and ultimately cost of communications inside vehicles. However, in this article, we will be dealing mostly with narrowband PLC over AC lines.


The narrowband PLC market is seeing healthy competition, with a large number of PLC suppliers joining the fray, including:

  1. サイプレス セミコンダクタ
  2. Echelon
  3. ST Microelectronics
  4. Yitran
  5. Texas Instruments
  6. Maxim
  7. Semitech Semiconductor
  8. Ariane Controls
  9. ADD Semiconductor
  10. Microchip

Companies in the broadband PLC segment include:

  1. Atheros
  2. Sigma
  3. Marvell
  4. Broadcom
  5. Lantiq
  6. Maxim
  7. Plugtek

PLC Technology: 詳しい使い方は?

PLC is like any other communication technology whereby a sender modulates the data to be sent, injects it onto medium, and the receiver de-modulates the data to read it. The major difference is that PLC does not need extra cabling, it re-uses existing wiring. Considering the pervasiveness of power lines, this means with PLC, virtually all line- powered devices can be controlled or monitored!

When discussing communication technology, it is often useful to refer to the 7-layer OSI model. Some PLC chips can implement only the Physical Layer of the OSI model, while others integrate all seven layers. One could use a Digital Signal Processor (DSP) with a pure software realization of the MAC and an external PHY circuit, or an optimized System-on-Chip (SoC) solution, which includes the complete PLC – MAC and PHY. The Cypress CY8CPLCXX series is an example of the latter, with a ready-to-use Physical and Network layer, and a user-programmable application layer. Before moving on to the applications of PLC, let’s first understand the various aspects of the Physical layer by viewing it as three segments on the basis of data rate.

PLC Technology Classification

Modulation Schemes

A variety of modulation schemes can be used in PLC. Some of these are Orthogonal Frequency Division Multiplexing (OFDM), Binary Phase Shift Keying (BPSK), Frequency Shift Keying (FSK), Spread-FSK (S-FSK) and proprietary schemes too (for example Differential Code Shift Keying (DCSK) from Yitran). In the table below, BPSK, FSK, SFSK and OFDM are compared on the basis of two important criteria – bandwidth efficiency and complexity (cost).

Comparision of Modulation Schemes

OFDM in particular offers high data rates, but requires computational horsepower to churn out Fast Fourier Transforms (FFT) and Inverse-FFT (IFFT), as required by the scheme. On the other hand, BPSK, FSK are robust and simple but offer lower data rates. The current trend is to move towards OFDM with PSK modulation (G3 and probably P1901.2). Such heavy computation will require DSP capability, whereas FSK, PSK and SFSK can be accomplished by a microcontroller.


Various standards have been developed in order to ensure reliable communications and inter-operability, especially for the smart grid and home networking. Examples of such standards are:

Narrowband PLC Standards

These, along with the organizations that govern them like CENELEC, FCC, ARIB, Homeplug Power Alliance specify ranges for operation of PLC. If a worldwide standard for PLC were to be established, this would have a positive impact on adoption of PLC. So far, the G3-PLC standard is touted as the most robust scheme available, and the IEEE 1901.2 working group is committed to developing a universally acceptable standard.


Different regions of the world have different frequency bands allocated to narrowband PLC. The table below summarizes the different frequencies available for narrowband PLC communication in the respective region.

Narrowband PLC Frequency Ranges


CENELEC - European Committee for Electrotechnical Standardization.
ARIB - Association of Radio Industries & Businesses.
EPRI - Electric Power Research Institute.
FCC - Federal Communications Commission.


Earlier, we saw that PLC is widely used in the Smart Grid and in micro-inverters. As the market gets familiar with this technology, PLC should see wider adoption in other applications like lighting (e.g. traffic light control, LED dimming), industrial (e.g. UPS communicating to a network device, irrigation control), machine-to-machine (e.g. vending machines, a hotel’s reception-to-room communication), telemetry (e.g. offshore oil rigs), transport (e.g. Electronics in cars, trains and airplanes) and indeed, applications of PLC are only limited by one’s creativity. In this article, we will find out a little more about PLC in energy generation and conservation markets.